MATERIAL SAFETY DATA 

CMT USA, Inc. 

Greensboro, NC 27407 

1-800-255-3924

(888) 268-2487 
(336) 854-0201 
SECTION I: IDENTIFICATION 


chemical name & synonyms 
N/A 
chemical mixture 
MIXTURE 
formula 
PROPRIETARY 
trade name 
CMT FORMULA 2050 
BLADE & BIT CLEANER 
Item number(s) 
description 
ORANGE COLOR LIQUID WITH FAINT SWEET ODOR, FOAMS 
EASILY 
CAS# 
N/A 

SECTION II: NORMAL HANDLING PROCEDURES 


precautions in storing and handling 
STORE IN COVERED AREA; KEEP FROM FREEZING 
protective equipment ventilation 
eye protection NONE WITH NORMAL USE 
gloves NONE WITH NORMAL USE 
other NONE WITH NORMAL USE 
NORMAL 
SECTION III: HAZARDOUS INGREDIENTS 


basic material CAS# percent OSHA PEL significant ingredients 
* 2-butoxyethanol 111-76-2 <4% 25 ppm 
SECTION IV: FIRE AND EXPLOSION HAZARD DATA 


flash point method 
WILL NOT BURN 
DOT hazard classification 
NON-FLAMMABLE 
flammable explosive limits 
upper N/A lower N/A 
extinguishing media 
NONE REQUIRED 
special fire hazard & fire fighting procedure 
THIS PRODUCT WILL NOT BURN 

SECTION V: HEALTH HAZARD DATA 
threshold limit value (TLV) symptoms of over-exposure 
N/A 
SECTION VI: EMERGENCY FIRST-AID PROCEDURES 


skin 
IF IRRITATED, WITHDRAW FROM FURTHER CONTACT. IF IRRITATION PERSISTS, GET MEDICAL 
ATTENTION 
eyes 
FLUSH WITH CLEAN WATER FOR 15 MINUTES. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION 
ingestion 
DRINK WATER, INDUCE VOMITING, GET MEDICAL ATTENTION 
inhalation 
REMOVE TO FRESH AIR. IF BREATHING IS LABORED, GET MEDICAL ATTENTION 

* Note: There is no occupational health risk associated with exposure to Formula 2050 in its 
finished form except for its being a mild eye irritant. (see section 7) 

SECTION VII: TOXICOLOGY 


acute oral LD50 NOT AVAILABLE carcinogenic 
acute dermal LD50 NOT AVAILABLE mutagenic 
acute inhalation LC50 NOT AVAILABLE eye irritation 
primary skin irritation 
NOT KNOWN TO BE CARCINOGENIC 
NOT KNOWN TO BE MUTAGENIC 
IRRITANT 
NOT AN IRRITANT 
principle routes of absorption 
DERMAL, ORAL, AND INHALATION 
effects of acute exposure 
MILD IRRITATION TO EYES AND MUCOUS MEMBRANES 
effects of chronic exposure 
NONE EXPECTED AT NORMAL USE LEVELS 

SECTION VIII: SPILL OR LEAKAGE PROCEDURES 


steps to be taken in case material is released or spilled 

SMALL SPILLS MAY BE FLUSHED TO MUNICIPAL SEWAGE DRAIN OR APPROVED WASTE WATER 
TREATMENT FACILITY. LARGER SPILLS SHOULD BE TRAPPED AND ABSORBED FOR RETURN TO 
RESERVOIR OR STORAGE TANK AFTER FILTRATION. RESIDUAL MATERIAL MAY BE REUSED OR 
FLUSHED AS DESCRIBED ABOVE. THIS PRODUCT WILL RENDER FLAT SURFACES EXTREMELY 
SLIPPERY. BE CAREFUL. 

waste disposal method 

TREAT OR DISPOSE OF ACCORDING TO REGULATIONS UNDER UTHE RESOURCE CONSERVATION AND 
RECOVERY ACTU AS ADMINISTERED BY U.S. EPA OR APPROPRIATE STATE AGENCIES 

SECTION IX: REACTIVITY DATA 


corrosive action (metals, plastics, rubber, etc.) 
OVER TIME, MAY TEND TO DULL ALUMINUM AND MAGNESIUM. DOES NOT AFFECT PLASTICS OR 
RUBBER SEALS 
Stability 
THIS PRODUCT IS STABLE 
conditions to avoid 
NONE 
incompatibility (materials to avoid) 
STRONG ALKALI METALS 
hazardous polymerization 
WILL NOT OCCUR 
hazardous decomposition products 
NONE 

SECTION X: PHYSICAL DATA


boiling point 
104†C 
vapor pressure 
NOT AVAILABLE 
volatiles 
melting point 
-8†C 
solubility in water 
SOLUBLE 
evaporation rate (ETHER = 1) 
SAME AS WATER 
specific gravity 
1.02 g/cm 
pH (100% solution) 
9.5-10.5 
specific vapor density (AIR=1) 
1.02 
cloud point (100% solution) 
41†C 


AUTHORIZED SIGNATURE ________________________ DATE _10-25-05_
_