FastCap, LLC

3725 Irongate Rd. Ste 105

Bellingham, WA 98226

U.S.A

Ph#(360)752-2138

Fax#(360)650-1075

Material Safety Data Sheet

Product: 2P-10 Activator

SECTION I

Chemical Name and Synonyms: HEPTANE & AMINE BLEND Trade Name and Synonyms: RiteLok AC 11

Chemical Family: MIXTURE Formula: N/A

 

Flammability: SERIOUS (3) Health: MODERATE (2) Reactivity: (0) 

SECTION II-HAZARDOUS INGREDIENTS

Hazardous Mixtures of Other Liquids, Solids, or Gases

 Listed as a carcinogen

 CAS NO % IARC, NTP, OSHA 

HEPTANE 142-82-5 > 90 NO NO NO 

N,N-DIALKYLTOLUIDINE 99-97-8 < 1 NO NO NO

SECTION III-PHYSICAL DATA

Boiling Point: (degrees F) 208oF Specific Gravity: >0.684 @ 77oF (H20 = 1) 


Vapor Pressure: (mmHg) 40 mm @ 68oF Percent Volatile, by Volume: 100%

Vapor Density: (Air=1) 3.5 g/l Evaporation Rate: HIGH 

Solubility in Water: IMMISCIBLE Color: WATER CLEAR 

Appearance: WATER THIN, VERY LOW VISCOSITY Odor: LIGHT HYDROCARBON ODOR

SECTION IV-FIRE AND EXPLOSION HAZARD DATA

Flash Point: 14oF (method used-T.C.C.) Flammable Limits: LEL: 1.1% UEL: 7% 

Extinguishing Media: CO2, FOAM, DRY CHEMICAL 

Special Fire Fighting Procedures: WEAR SELF CONTAINED BREATHING GEAR & PROTECTIVE CLOTHING. 


Unusual Fire and Explosion Hazards: DIRECT WATER JET WILL SPREAD BURNING MATERIAL. COMBUSTION PRODUCTS 

 ARE VERY TOXIC & HIGHLY IRRITATING. COOL SEALED DRUMS WITH WATER SPRAY TO LESSEN CHANCE OF RUPTURE. 

 CONTAINER EXPLOSION CAN OCCUR, VAPOR FORMS EXPLOSIVE MIXTURE IN AIR.

SECTION V-HEALTH HAZARD DATA

Threshold Limit Value: SHORT TERM 500-PPM, TWA 400PPM 

Effects of Overexposure: INGESTION-IF SIGNIFICANT QUANTITY INGESTED, MAY DULL SENSES (ORAL LD50 > 5000 

 Mg/Kg). INHALATION-MAY CAUSE NAUSEA, HEADACHE, DIZZINESS AND IRRITATION OF RESPIRATORY TRACT. SKIN 

 AND EYES-IRRITATION ON CONTACT. (Est. DERMAL LD50 > 2000 Mg/Kg).

Emergency and First Aid Procedures: INGESTION-DO NOT INDUCE VOMITING. KEEP INDIVIDUAL CALM. OBTAIN 

 MEDICAL ATTENTION. INHALATION-REMOVE TO FRESH AIR (OXYGEN OR ARTIFICIAL RESPIRATION IF NEEDED) 

 OBTAIN MEDICAL ATTENTION (NOTE TO PHYSICIAN: USE OF EPINEPHRINE IS CONTRA-INDICATED). SKIN-WASH WITH SOAP 
AND WATER. REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE REUSE. EYES-FLUSH EYES IMMEDIATELY WITH WATER A 
MINIMUM OF 15 MINUTES. IF IRRITATION PERSISTS CONTACT A PHYSICIAN.

SECTION VI-REACTIVITY DATA

Stability: STABLE.

Incompatibility (Materials to avoid): STRONG OXIDIZERS, SOURCES OF IGNITION

Hazardous Decomposition Products: CARBON MONOXIDE, CARBON DIOXIDE. 


Hazardous Polymerization: WILL NOT OCCUR.

SECTION VII-SPILL OR LEAK PROCEDURES

Steps to be taken in case material is released or spilled: EXTREMELY FLAMMABLE. KEEP ALL SOURCES OF IGNITION 
AND HOT METAL SURFACES AWAY FROM SPILL. PREVENT MATERIAL FORM ENTERING SEWERS OR NATURAL WATERWAYS. PERMIT ONLY 
PROPERLY PROTECTED WORKERS WITH SKIN & EYE PROTECTION AND SELF CONTAINED BREATHING GEAR. ABSORB SMALL SPILLS 
WITH ABSORBENT MATERIAL, PUMP LARGE SPILLS INTO SALVAGE TANKS.

Waste disposal method: RCRA HAZARDOUS WASTE. INCINERATE IN ACCORDANCE WITH EPA AND LOCAL REGULATIONS. 

SECTION VIII-SPECIAL PROTECTION INFORMATION

Respiratory protection (type): ABOVE TLV. NIOSH/MESSA APPROVED RESPIRATOR. 

Ventilation: LOCAL EXHAUST RECOMMENDED.

Protective Gloves: RESISTANT PLASTIC OR RUBBER.

Eye Protection: CHEMICAL SPLASH GOGGLES RECOMMENDED.

Other protective equipment: PROTECTIVE PLASTIC OR RUBBER APRON.



SECTION IX-SPECIAL PRECAUTIONS

Precautions to be taken in handling and storage: STORE IN A COOL DRY PLACE. 

Other precautions: KEEP AWAY FROM EXCESSIVE HEAT & FLAME. KEEP CONTAINER CLOSED WHEN NOT IN USE, KEEP 

 WELL VENTILATED. AVOID CONTACT WITH EYES, AVOID VAPOR. KEEP AWAY FROM CHILDREN.

 SECTION X-TRANSPORTATION

Dot (49 CFR 172) UN#: 1206

Proper Shipping Name: Heptane Solution Packaging Group: II

Hazard Classification: 3 Hazard Label Required: Flammable Liquid

Information presented herein has been compiled from sources considered to be dependable and is accurate and reliable to the best of our knowledge and 
belief but is not guaranteed to be so. Nothing herein is to be constructed as recommending any practice or any product in violation of any patent or 
in violation of any law or regulation. It is the userís responsibility to determine for himself the suitability of any material for a specific purpose 
and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since 
conditions of use are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.

REVISED 12/11/2001

MSDS AC11